Estimate Appliance Electricity Cost From Watts and Hours

Start with the task you actually need to finish

  • Working out how much an air conditioner is adding to a monthly electricity bill.
  • Comparing the running cost of an old appliance against a more efficient replacement.
  • Estimating the cost of running a water heater for a set number of hours daily.

A practical check before you begin

A 1,500-watt appliance drawing that power continuously for six hours uses nine kWh. At an illustrative 25 per kWh, that is 225 before additional charges. A thermostat can cycle the appliance off, changing actual consumption.

Follow the workflow and review the result

  1. Add an appliance and enter its wattage rating, usually printed on the device or its manual.
  2. Enter the average number of hours per day the appliance runs.
  3. Enter your electricity tariff per unit (kWh) in your local currency.
  4. Repeat for each appliance you want to include in the estimate.
  5. Review the total estimated monthly units and cost across every appliance added.

Converting watts into units

Units used per day equal wattage multiplied by hours used per day, divided by 1000 to convert watts into kilowatts. Multiplying that daily figure by 30 gives a rough monthly total, and multiplying by your tariff per kWh gives the estimated cost.

Which appliances use the most electricity

Air conditioners, water heaters, irons and electric ovens tend to dominate a typical bill because they combine high wattage with long run times, whereas lower-wattage devices like phone chargers contribute comparatively little even when left running constantly.

Accuracy compared to an actual bill

This is an estimate based on the figures entered — actual bills can vary due to tiered tariff rates, standing charges, seasonal usage changes, and appliances not running at a constant load the whole time they're switched on.

Using a meter reading to check the estimate

Comparing the calculator's estimated monthly units against the difference between two meter readings a month apart is a good sanity check, and can reveal appliances not accounted for in the estimate.

Limits worth knowing before you rely on the output

Metered usage is more reliable than nameplate power times assumed hours. Fixed charges, tax, and tiered rates are separate.